This is a three parts chemical setting polyester resin
base mortar. It exhibits excellent adhesion to acid
resistant bricks/tile, concrete, surface. polyester
is resistant to very wide range of chemicals.
Due to very low
absorption and very high chemical & physical
properties polyester can be used for acid
resisting brick/tile lining, on floors, drains, reaction &
storage vessels, sumps, effluent treatment plants of
food/pharmaceuticals, Breweries, Dairies, Water
treatment plants etc.
|Mix Ratio by wt. Sol to
|Compressive Strength kg/cm2
|Flexural Strength kg/cm2
|Bond Strength kg/cm2
OF APPICATION MIXING:
All mixing tools
and pan must be clean, dry. Take appropriate
quantity of resin and hardener and mix it thoroughly
with suitable means, until you get homogeneous mix.
Then add powder slowly in it and start mixing slowly
to avoid air trapping. The ratio can vary depending
upon ambient temperature and working conditions.
After proper mixing of mortar
should be buttered on back and sides of bricks/tiles
to be laid. Apply little more mortar and after laying
squeeze the excess mortar. If only a joint filling is to
be done with polyester, be sure that full depth of
joints is filled with mortar. There should not be any
air pocket in the joints. During & after completion
of the installation, area must be kept dry and free
from any other materials, traffic, which can affect
setting & curing of polyester.
highly resistant to acids, salts, solvent oil and grease.
Performance of polyester in the presence of
oxidizing chemicals makes it ideal for bedding& jointing
material for use in the presence of chlorine and bleaching
solutions, nitric and chromic acids. It
is used widely in paper & pulp industries and
||STORAGE & SHELF
Always keep resin,
catalysts and powder in cool, dry place, away from
direct sunlight and moisture. If stored n sealed
containers and bags; shelf life of Resin, Harder & Powder
will be one year.
10 kgs & powder 40 kgs.
HEALTH & SAFETY:
It is advisable to wear protective wears at the time
of use of polyester, and all our other products. In
case of contact with eyes & skin. wash with plenty
of water and consult a doctor. Adequate ventilation
of working are is recommended. This information, given
in good faith, is based on results gained from experience
and tests. However, all recommendations or suggestions
are made without guarantee since the conditions of use
are beyond our control.