level epoxy is based on high performance epoxy
resin & curing agents. This is a three-component
system of resin, curing agent and carefully graded
high abrasion/chemical resistant fillers. Product
is self-leveling to achieve excellent gloss, attractive,
hygienic and very hardwearing & chemical resistant
- Being smooth joint less and monolithic surface it
is very easy to clean and to make it dust free.
- Product is based on high performance epoxy resin & curing
agent system. The flooring system has excellent
overall chemical resistance at ambient temperature.
- Carefully selected and graded high wearing aggregates
give very strong floor toppings to withstand
normal foot and light vehicular traffic
- System is available in many attractive colors.
S/L Epoxy is highly recommended,
for use, for extremely hygienic condition, chemical
resistant and dust free areas like:
Food Processing Industries
to 2.9 kg/cm/m(Approx)
Trowel & Spakie Roller
Hrs Full 7 days
directed on Packing
Green, Red, Black, White or as required
PREPARATION : Successful performance
of S/L Epoxy or any other flooring system can
achieve only after proper surface preparation.
It is the prime requirement, that surface must
correctly prepared before application.
- New concrete or cementations surface must be
cured for 28 days.
- Surface must be free from any oils, grease, loose
particles, curing aid chemicals, previously applied
- Surface must be fully dry.
- For old surface all cracks, cavities should be
repaired with MIPRO-E mortar
- This is a very thin topping so can not level
any irregularities of levels of the original sub-base.
Therefore, it is most important to make original
surface in line & level, before application
of MIPRO-E S/L
PRIMER COAT: Apply one coat
of Epoxy primer on properly prepared surface by
brush and allow it to dry.
SELF LEVEL TOPPLING: First mix the resin part A,
thoroughly with slow speed mixer until uniform color
is achieved. Then add curing agent part B and mix
again with mixer. After that, add filler par C and
mix with mixer until a homogeneous, lumps free mass
Then, pour it on primed surface and work with notched
trowel to required thickness and apply spike roller
to remove air. Proper mixing is the key factor to
get uniform color and smooth surface.
STORAGE: All the components Resin, Hardener & Filler
must be kept in cool, dry place and in covered shed.
HEALTH & SAFETY: It is advisable
to wear protective wears at the time of use of
S/L Epoxy and all other our products. In case
of contact with eyes and skin, wash with plenty
of water and consut a doctor.
This information, given above in good faith, is
based on results gained from experience and tests.
However, all recommendations or suggestions are made
without guarantee since the conditions of use is
beyond our control.