BASE EPOXY SELF LEVEL FLOORING :-
Water base epoxy self level epoxy flooring is a
third generation “water-based” 3 component,
epoxy flooring system that outperforms and
outlasts most solvent based and solvent free
flooring systems without the associated
odors, flammability, or VOC’s.
3) Excellent Adhesion
4) Applies to Damp Concrete
5) Excellent Gloss & Gloss Retention
6) Good Color
7) Excellent Stain Resistant
8) Excellent Hardness Development
9) Rapid Dry Time
10) Easy Clean-up
Water base epoxy SL is recommended for
>Clean room flooring,
> High abrasion resistant flooring
The recommended application of this product is by notch
trowel and spike roller. Allow water base epoxy SL to
dry thoroughly before mixing and applying the next coat.
It should be tack free and clear in appearance before
|| Typical Value
| Shelf Life
|| 1 year in sealed
container in cool, dry
| Mixing Ratio by wt.
|| As mention on
| Coverage 2mm th.
|| 3.4-4.5 kg/M2
| Application Method
|| Notch trowel & spike
| Ready for Foot
|| 36-48 hrs.
| Ready for Heavy
|| 7 days
| UV Light Resistant
|| Self extinguating
| Water Absorption
|| Less then 1%
10 Kgs., 25 Kgs & 50
Kgs Units of Part A & B
This product should be applied at the rate of
approx. 3.5-4.5 kg/M2 for approx. 2mm thick
The substrate must be clean, dry and sound
with new concrete cured for at least 28 days.
Remove dust, laitance, grease, curing
compounds, waxes, foreign particles,
disintegrated or soft base materials, and any
previously applied coatings. Create a surface profile
on concrete by either steel shot blasting or acid etching.
Repair cracks and joints with EPOXY CRACK & PATCH
mortar. If the concrete surface is not prepared properly,
product adhesion will fail and warranties will be voided.
> For interior use only
>New Concrete must cure for 28 days
> DO NOT thin Water base epoxy
> DO NOT use when humidity Exceeds
> DO NOT allow material to Puddle during
> Allow each coat to Dry Tack-Free and
clear before Recoating
> Apply Each Coat Within 24 hours of
> Do NOT APPLY to Structurally Unsound
> Apply a Test Patch to Ensure Adhesion to
Avoid mixing and application of this product if
the surface temperature is high and humidity
is higher then 70% R.H. The temperature of
the surface, materials and air in the area of
installation all play a role in how the product
will apply and cure. Stair part A & B
separately and then pour part `B in to part A
in proper ratio and blend thoroughly for
minimum for 2-3 minutes with a spiral mixing
blade attached to a low-speed electric drill.
Take care not to induce air into the material
when mixing. This will cause bubble in the
coating when applied.
At 30o C and 50% R.H. the water base epoxy has a useful
working time or pot life of 25-30 minutes. Using any
product beyond this time will result in variable results
and therefore any mixed product beyond the pot life
should be discarded.
HEALTH & SAFETY:
It is advisable to wear protective wears at the time
of use of water base epoxy and all other our products.
In case of contact with eyes and skin, wash with plenty
of water and consult a doctor. This information, given
above in good faith, is based on results gained from
experience and tests. However, all recommendations or
suggestions are made without guarantee
since the conditions of use is beyond our
Application equipment should be cleaned
using soap and water.